Foxwell NT530 1998 bmw m3 e36 oil / service / maintenance reset

Have 1998 BMW M3 e36 to reset oil/ service / maintenance, Foxwell NT530 is able to do this job manually instead of automatically.

Foxwell NT530 1998 bmw m3 e36 oil / service / maintenance reset 

 

This is the operation guide:

  1. Let’s go on with searching the diagnostic connector(the black cylinder).It is located in the engine compartment, near the brake fluid box.
  2. You have to remove the cap on top and you’ll see a 20 pin connector.
  3. Our interest is to use the pins 7 and 19, necessary to reset oil service light BMW 3 Series E36.
  4. Now make sure that the ignition switch is in position 0 (that means no operating of any kind).
  5. Remove the key.
  6. Then place a jumper wire (refer to the end of this file) between the pins 7 and 19.
  7. When you see the OILSERVICE light in the instrument cluster, it’s time to perform an reset oil service light BMW 3 series E36. When the wire is palced, take the key and insert it int to the ignition switch.
  8. Turn the ignition switch to position 2 (run, no start). After approd 3 seconds you shold remove the jumper wire.
  9. You will see that the OIL SERVICE light disappears and all the green lights come out.
  10. Turn the switch back to position 0, remove the key.
  11. Replace the cap on the diagnostic connector and close the engine compartment.

 

Good source of Foxwell NT530 BMW scanner: www.foxwelltool.com

(Visited 10 times, 1 visits today)
Foxwell NT530 1998 bmw m3 e36 oil / service / maintenance reset
Share